Auto power-on & shut-down full
Connectors g (31.43 KiB) Viewed 18705 times.
When our program is running and detects a loss of the main supply, we can go through a UPS period to see if it was only a short Brown-Out, in which case it can go back to watching the next power drop.
But that's not all.
Auto Power-on Shut-down can be set to start together with Windows and always run minimized, for not tempering with the user's work.So, we will use one additional gpio port to drive an LED, and use that to tell us what the application program is doing.Again, so far, so good.Using the vmware Command for more information.The period of about 45 seconds is created with the 390K and the 100uF capacitor.If it doesn't turn on, then the computer is not compatible with the power-on feature.As soon as the main power is available, it needs to be activated.This printmaster - platinum version 18 windows 7 can easily be done by a voltage divider.The most simple and reliable design I found is one where the basic default is to remove power from the Pi a little after the shutdown, and to control the automatic start of the system by applying power again.If we want to protect the Pi input, we not only need to worry about the voltage level, because even more important is the amount of current; that is the real killer.
If you select the soft setting, Start Up Guest appears instead.
But what if it comes back while we are shutting the Pi down?As the name clearly suggests, the program allows anyone to program the operating system to automatically shut down itself using various settings.The following circuit does the job.These are two pins across from each other on the P1 connector.The timer will be used to guarantee clean power during the shutdown process, and to control the power-switch that will automatically turn off the power.